This part is a perfect fit for my Panasonic FZ-M1 Mk3, required little cleanup, and had impressive attention to detail - there's even geometry to match the FZ-M1's water/dust seal perfectly. Very easy installation.
I picked up a Panasonic FZ M1 to use with my marine diagnostics kit. The ram mount I have for the tablet wouldn't work with the bar code scanner. I wasn't sure I could remove it since I didn't see any parts listed for this discontinued model. After searching, I found a link for a 3D printed flush mount cover from comms depot. Perfect fit, easy install, and it arrived in mere days. Very pleased!
This back cover fits great on my FZ-M1 Mk1. It replaced a RJ45 with hot swap battery back cover. I never liked that cover because it stuck out and made the device too bulky and weirdly shaped to be a proper handheld tablet. Now with this flush cover my FZ-M1 is properly fitting in hand vertically as a tablet should. The cover has overall good construction. It fits solidly on the tablet. The price is right. No complaints.
this just arrived and in 5 minutes is on my fz-m1!!
Super easy install, built well with a ridged back for stability and the texture is nice. One of my complaints with the fz-m1 is its slippery back, which is not good for field work.
I'm not sure what they made this with but it was a good choice of materials.
Significant weight loss, too.
highly recommend
Amazing thought behind trimming down the DIGIRIG by HALF!!!! This has been a true hero for space saving in my system as I do a lot of field work using digital modes. The precision in the design leaves doing this swap a breeze. And the unit has held up too many hikes along with a lot of abuse as my gear is bought to be used and used extensively.
James Crutchfield –
This part is a perfect fit for my Panasonic FZ-M1 Mk3, required little cleanup, and had impressive attention to detail - there's even geometry to match the FZ-M1's water/dust seal perfectly. Very easy installation.
Jerry –
Perfect replacement cover when removing barcode scanner from my Panasonic FZ M1. Well made, product, great fit, quick shipping!
Jerry –
I picked up a Panasonic FZ M1 to use with my marine diagnostics kit. The ram mount I have for the tablet wouldn't work with the bar code scanner. I wasn't sure I could remove it since I didn't see any parts listed for this discontinued model. After searching, I found a link for a 3D printed flush mount cover from comms depot. Perfect fit, easy install, and it arrived in mere days. Very pleased!
Senza –
This back cover fits great on my FZ-M1 Mk1. It replaced a RJ45 with hot swap battery back cover. I never liked that cover because it stuck out and made the device too bulky and weirdly shaped to be a proper handheld tablet. Now with this flush cover my FZ-M1 is properly fitting in hand vertically as a tablet should. The cover has overall good construction. It fits solidly on the tablet. The price is right. No complaints.
mike –
this just arrived and in 5 minutes is on my fz-m1!! Super easy install, built well with a ridged back for stability and the texture is nice. One of my complaints with the fz-m1 is its slippery back, which is not good for field work. I'm not sure what they made this with but it was a good choice of materials. Significant weight loss, too. highly recommend
unpaved_expeditions –
Amazing thought behind trimming down the DIGIRIG by HALF!!!! This has been a true hero for space saving in my system as I do a lot of field work using digital modes. The precision in the design leaves doing this swap a breeze. And the unit has held up too many hikes along with a lot of abuse as my gear is bought to be used and used extensively.